1978 hz kingswood ute. Phil Baker built red holden 308 stroked to - TopicsExpress



          

1978 hz kingswood ute. Phil Baker built red holden 308 stroked to 383, yella terra dash 3 heads(fully ported and polished see pic for engraving) srp forged flat tops, hasting rings, camtech solid roller cam, ARP main studs,750Holley ultra hp double pumper billet carb, msd 6al 2 ignition.list goes on. Made 487 hp on phils engine dyno @5900 and 488 ft/pd @4500rpm. pacemaker 1 5/8 4 into1s,Dual 2.5 inch exhaust into pacemaker x pipe, nice note not over the top. Tremac TKO 5 speed, 3 inch t/shaft oversized unis. Ford 9 inch 3:55 tru trac centre, mark Williams billet axels. 18x8 &18x9 showwheels steeters with %90 rubber. rare spares floors welded in , heat proof/ sound deadener installed and new carpet. the rest of interior is ok. Paint is ok with some defects, see photos. I have spent around 40k on this ute, mechanically u wont find better motor and driveline have less than 25000km. Perfectly fine to drive around as is, or paint and have something worthy of summernats. when I got the new motor built I drove it sparingly for 12 months, it ran out of rego I brought a truck for business we had a baby hence no room and with 3 registered vehicles already on the road it will not be again. I set this ute up as vehicle to drive not race, it makes great power at low revs, 400km to a tank 98 octane only it sits on 1900rpm@100km. it will sit in traffic pwr alloy radiator with temp controlled thermo fan and has enough power and tourque to put a smile on your dial. I will not part with this ute for less than $15000 thats what the motors worth let alone anything else. Located Dubbo NSW. Can provide blue slip.
Posted on: Sat, 09 Aug 2014 02:24:56 +0000

Trending Topics



Recently Viewed Topics




© 2015