So, i had to replace my intake on the mousetang, well i decided not to use the normal frpp replacement, but a speedmaster/procomp all aluminum piece. had to dig out the diegrinder and cleanup all the flashcasting and then sand with 80 grit. so far so good, power is up everywhere, its smoother and the powerband seems to be much better than before. The engine is a NPI and the intake is a PI, used couple dabs of silicone on the water ports, had to use two of the screws provided whith the kit, and used felpro pi gaskets. had to grind a little on the bottom to get it to fit, but nothing major.
Posted on: Sun, 05 Oct 2014 19:26:50 +0000
Trending Topics
Recently Viewed Topics
© 2015