There are some question posted in other group, if it is of some use to you. Try to answer and post with question, so that viewers can judge and also could be useful to other friends. So do not hesitate, even if answers are wrong. We all learn from our mistakes. So wish every one good luck. So here are the question, put up by our Great Well Wisher Mr. Ventakesan Rama. SURFACE PREPARATION RELATED QUESTIONS. 1. What standards are you familiar with, in surface preparation? 2. What salt extraction and analysis method are you familiar? 3. How often will you carry out salt test? 4. How will you check the surface cleanliness and what parameter will you accept? 5. IF the surface cleanliness is good and profile is less, will you accept for further painting? 6. Selection of abrasive and types of abrasives. 7. What are the types of Abrasives you are familiar with? 8. What types of test you will carryout to make sure that the abrasive is clean and correct size? 9. What is blotter test? 10. How often u will carry out blotter test. 10. In case of contamination found in blotter test what is your action. 11. What is environmental requirement while blasting and painting? 12. What is the substrate temperature mandatory requirement while blasting and painting? 13. What inspection instruments needed to check all related to blasting surface preparation 14. What is dust tape or sensitive tape test? 15. How you will rate dust and record 16. What is the minimal blasting pressure required? 17. Types of substrates, surface preparation and profile requirement. 18. For SS material what abrasive you will use and conditions of blasting 19. Why SS surface requires painting 20. How you will checking blasting pressure. 21. What is the distance between blasting nozzle and substrate? 22. What is sweep or brush off blasting? 23. Type of hand and power tool cleaning method. 24. Why solvent cleaning required and purpose. 25. What are the solvent cleaning standard and manual and power tool cleaning standards? 26. What are your governing documents during your course of inspection? 27. In case of any conflict what you will do initially. 28. How you will select and qualify blasting abrasives 28. What is rust grades and define 29. After blasting acceptance within how many hours/days/months the paint application shall proceed? 30. In case after blasting if the duration exceeds for painting, what effects you will notice, will you accept as it was for painting or will you demand for full blasting or sweep blasting? 31. In case contractor used contaminated abrasive, what action you will take. 32. If approved to use recycled abrasive, what test method you will initiate? 33. Before inspecting any job, what document you will check. 34. In case of wrong information in any document will you proceed directly or request for clarification with client 35. Daily inspection check list 36. What is all the daily check you will carry out before blasting? 37. If a workers all working in unsafe working method, will you stop the job or inform their supervisor or record the conditions? 38. Are you responsible for safety, please define 39. Have you got experience in painting shop or site/field? 40. In field, what types of safety precaution you will adhere? 41. How you will record all your finding and information 42. Which report will tell you all the needed information? 43. Can you prepare job specific inspection report / inspection test plant / method statement (if needed). 44. In your experience what types of malpractice experience from contractors and how you will control and correct in case deviations. The all the above question may form surface preparation questions.
Posted on: Sun, 09 Mar 2014 10:45:08 +0000
Trending Topics
Recently Viewed Topics
© 2015