Well Most of you saw my other design, so I feel i should share with you my bullpup DAM design Consept. As you can tell it takes Design Aesthetics from a Tavor 21 or Tar 21 in the hand guard/front IRS secton. Marker pictured with a 13ci tank ( forgive the look as the tank is not scaled properly to the gun. Similar to my other design this one can use hopper or magazine feed. using a feed neck elbow, but truely shines with a ripclip, It too will have the holes for attaching the ripclip to the gun already making install simple. With it being a bullpup design and having a dual loader system it will be quite heavy in the back end but will be more compact, and the wight will be supported by one shoulder when in use. Also by using a ripclip which is side mounted to the stock section you can use a traditional X7 hopper or a tack cap and not have any issues still being able to sight down any optics you have on your top rail. The top rail is of course an angle adustable rail using an adjustment knob the works gears to lift the back of the rail up or down while leaving the front stationary. Unlike my other design this one would use a select fire switch to allow for a true safe mode without having to turn off the marker, where the other design used the pre-exsisting button/micro switch board on the dam. I felt that a select fire switch in addition to the power button and eye button, would allow for more simplicity and less general wear and tear issues.
Posted on: Fri, 28 Mar 2014 23:25:07 +0000