status maintenance : Done action : pengalihan bts ke pura berikut datanya : [admin@ptp_pura-zulfa.net3-911] > tool bandwidth-test 10.6.1.131 user= xxx duration=10s direction=receive status: done testing duration: 10s rx-current: 80.6Mbps rx-10-second-average: 50.0Mbps rx-total-average: 50.0Mbps lost-packets: 802 random-data: no direction: receive rx-size: 1500 [admin@ptp_pura-zulfa.net3-911] > tool bandwidth-te duration=10s direction=transmit status: done testing duration: 10s tx-current: 81.1Mbps tx-10-second-average: 47.7Mbps tx-total-average: 47.7Mbps random-data: no direction: transmit tx-size: 1500 [admin@ptp_pura-zulfa.net3-911] > in wi pr advanced Flags: X - disabled, R - running 0 R name="wlan1" mtu=1500 mac-address=D4:CA:6D:5B:2D:7B arp=enabled disable-running-check=no interface-type=Atheros AR9300 radio-name="ptp_pura_zulfa" mode=bridge ssid="zulfha3" area="" frequency-mode=superchannel country=no_country_set antenna-gain=0 frequency=5235 band=5ghz-a/n channel-width=20mhz scan-list=5100-5400 wireless-protocol=any rate-set=configured supported-rates-a/g=6Mbps,9Mbps,12Mbps,18Mbps,24Mbps,36Mbps basic-rates-a/g=6Mbps max-station-count=2007 distance=dynamic tx-power-mode=default noise-floor-threshold=default nv2-noise-floor-offset=default periodic-calibration=enabled periodic-calibration-interval=60 dfs-mode=none wds-mode=dynamic wds-default-bridge=bridge1 wds-default-cost=100 wds-cost-range=50-150 wds-ignore-ssid=no update-stats-interval=disabled bridge-mode=enabled default-authentication=yes default-forwarding=no default-ap-tx-limit=0 default-client-tx-limit=0 proprietary-extensions=post-2.9.25 wmm-support=disabled hide-ssid=no security-profile=default disconnect-timeout=3s on-fail-retry-time=100ms preamble-mode=short compression=no allow-sharedkey=no station-bridge-clone-mac=00:00:00:00:00:00 ht-ampdu-priorities=0 ht-guard-interval=any ht-supported-mcs=mcs-0,mcs-1,mcs-2,mcs-3,mcs-4,mcs-5,mcs-6,mcs-7,mcs-8,mcs-9,mcs-10, mcs-11,mcs-12,mcs-13,mcs-14,mcs-15,mcs-16,mcs-17,mcs-18,mcs-19,mcs-20, mcs-21,mcs-22,mcs-23 ht-basic-mcs=mcs-0,mcs-1,mcs-2,mcs-3,mcs-4,mcs-5,mcs-6,mcs-7 ht-txchains=0,1 ht-rxchains=0,1 ht-amsdu-limit=8192 ht-amsdu-threshold=8192 tdma-period-size=2 nv2-queue-count=2 nv2-qos=default nv2-cell-radius=30 nv2-security=disabled nv2-preshared-key="" hw-retries=7 frame-lifetime=0 adaptive-noise-immunity=client-mode hw-fragmentation-threshold=disabled hw-protection-mode=none hw-protection-threshold=0 frequency-offset=0 rate-selection=advanced multicast-helper=default [admin@ptp_pura-zulfa.net3-911] > in wi reg pr # INTERFACE RADIO-NAME MAC-ADDRESS AP SIGNAL... TX-RATE UPTIME 0 wlan1 cpe_zulfha3 D4:CA:6D:5B:1B:87 no -57dBm... 144.... 1h16m12s [admin@ptp_pura-zulfa.net3-911] > system resource pr uptime: 2h34m30s version: 5.25 free-memory: 17016KiB total-memory: 29696KiB cpu: MIPS 74Kc V4.12 cpu-count: 1 cpu-frequency: 600MHz cpu-load: 14% free-hdd-space: 91772KiB total-hdd-space: 126976KiB write-sect-since-reboot: 408 write-sect-total: 28174 bad-blocks: 0% architecture-name: mipsbe board-name: RB911G-5HPnD platform: MikroTik
Posted on: Sun, 23 Jun 2013 04:04:05 +0000
Trending Topics
Recently Viewed Topics
© 2015