FOR SALE Mathew Dance’s 2014 National Championship winning engine. Vauxhall 1410cc 8 valve engine. 136.2mm steel rods plus ARP bolts. (Brand new in August) 78.4mm omega pistons. (Brand new in August) Balanced & tufrided 73mm crank. Steel fly wheel. Full race head. 39ml inlets. 34ml exhaust valves Compression 11.5:1 Piper cam. New Kent solid lifters SBD dry sump system,pump,tank and filter housing Jenvey throttle bodies,running on 8 injectors and a penny and giles throttle pot sensor. Runs on a Omex 710 system and loom. Warming up sequence programmed into it, it wont rev more than 3000 revs until its over 60 degrees.... Oil pressure sensor shuts engine off automatically if the pressure drops below 10 psi. Also fully wired and programmed to run on a Dash 2 race technology dash screen which is included with the engine! The engine is fully mapped by Dave at MEK Motorsport in Cheltenham and produced 162 bhp (at the flywheel) and 118 lbs of torque at 8850 rpm. Was stripped and checked last week by a seasoned engine builder with a deep history in competition engines and it’s not done much more than about 30 miles since being built new! With a preference for preservation rather than repair, this engine has never wanted for anything, everything is perfect. Also included are: Sytec competition fuel pump and mounting bracket Cam sensor Injectors sensor Tps sensor Water temp sensor Oil pressure sender sensor and crank sensor. Ecu box with switches built in included. 2 sets of competition magnecor 10mm plug leads 2 coil packs 2 Tps sensors Crank sensor Dry sump pump belts K&N filters A bargain compared to its build and development cost, £8000 buys it. For sale due to change of class.
Posted on: Tue, 18 Nov 2014 21:56:29 +0000
Recently Viewed Topics
© 2015