I copied a split fender mod seen on this page. I like it. Props to the OP. I ordered PlanetX 29er fenders, drilled out all the rivets and separated the hardware. Then, I used masking tape to create a cut line and used tin snips to split the fenders down the middle. I did the same around the circumference of a Rubbermaid trash can from TrueValue Hardware Store ($14.99) and fastened together with 3/16 rivets, using washers where the hardware wasnt. I cut an 8 cm strip for the rear fender, and a 10 cm strip for the front fender. there is an inch gap around the 4 tires, it is out of the way of the front derailleurs, there are spacers to clear the calipers... but on the Vinson, I had to use small random aluminum 1/4 ID tubes as spacers at the fork tips. the fenders are gloss and the plastic can strips are semi gloss. they are both black and similar shades, but a camera makes them appear more different than they otherwise look. When you cut around a barrel that tapers, realize there is a subtle curve, knowing this now I would cut a little larger, lay it out and cut straighter strips for more easily avoiding gaps or twisting. start riveting at one end and do one side at a time. tin snips and rivet guns really tone the forearms! no more grit, grime, salt, glass, dirt, carrion, swill in my eyes and teeth, or being drenched by frigid water. I am impressed with the strength of the fenders, and prefer the aesthetic to other fender mods I have seen. I have enough barrel left to make strips for another fat bike fender mod!
Posted on: Tue, 20 Jan 2015 23:44:12 +0000
Trending Topics
Recently Viewed Topics
© 2015