IS THERE A DIFFERENCE BETWEEN .223 AND 5.56? The comparison between .223 and 5.56 isn’t a new one, so there is a lot of discussion to weed through to learn about the two. Ultimately, because they originated from the same cartridge, they are very similar, but that does not mean that they are necessarily interchangeable. This article discusses three key differences between .223 Remington and 5.56x45mm NATO. .223 Remington and 5.56x45mm Dimension Measurements. At a glance, the two rounds are indiscernible. Both rounds use a bullet of .224in in diameter and an overall length of 2.26in. In general, the external dimensions for the two calibers are identical. What’s more significant is the pressure of the two rounds and the difference in the rifle chambering. .223 Remington and 5.56×45 Pressure Measurements One of the problems with comparing these two cartridges is that they utilize different methods of measuring pressure. SAAMI (Sporting Arms and Ammunition Manufacturers’ Institute) measures the .223 pressure at the center of the casing, whereas the NATO standard measures the pressure at the throat (or leade) of the chamber. To rectify the two different methods, several have undertaken experiments with their own standardized recording method to compare “apples to apples.” One such thorough study was carried out and recorded in detail by Andrew Tuohy posted via Lucky Gunner Labs (click here to read the full article). Tuohy evaluated various .223 and 5.56 ammo fired through rifles chambered for .223 Remington and 5.56x45mm. His, and the research of others, confirms that, generally, shooting .223 through a 5.56 chamber results in lower pressure, but still functions (safely). Firing 5.56 through a .223 chamber, however, results in somewhat higher pressures. Although the differences aren’t massive (~5% in the previously referenced study), extensive firing of 5.56 through a .223 chamber could lead to over-pressure malfunctions, such as popped primers or blown cartridge case heads and other firearm malfunctions. .223 Remington and 5.56×45 Chamber Differences The most important difference between .223 and 5.56 chambers is the length of the throat (or leade) for each chamber. More specifically, the leade is located at the mouth of the barrel before the rifling occurs. Comparing the NATO and SAAMI regulations, the leade for 5.56 chambers is nearly twice as long as that of a .223 chamber (.162in to .085in, respectively). If a 5.56 round contacts the barrel rifling too early, it can cause pressure spikes (leading to malfunction, and potentially damage) in the chamber. This explains why it is safe to fire .223 through a 5.56 chamber, but not recommended to fire 5.56 through a .223 chamber. While manufacturers load to different specs, the only intrinsic differences between .223 and 5.56 ammo is the case wall thickness (a little thicker in 5.56), and the max pressure being a touch higher in 5.56, although most 5.56 ammo is not loaded to max. The bigger difference is in the chambers. .223 by spec (in the real world it varies between manufacturers) is a tighter chamber and shorter leade than 5.56 and as such the .223 will produce slightly higher pressures with the same ammo.
Posted on: Mon, 11 Aug 2014 22:57:44 +0000
Trending Topics
Recently Viewed Topics
© 2015