Ok guys, looking for some advice before I finalize my ANT 250 setup. I wasnt sure where I wanted to put the ESCs, so I decided to match them to the picture on the website and put them on the bottom. I would have put them on the arms for air but didnt want to trim my motor wires in case I want to sell them at some point. Now I am trying to decide how to wire all my power. Was thinking about soldering everything together on the underside. Looking for any thoughts on those points. Lastly, I want to nail down my fpv setup. I have a möbius I have been contemplating using for love video, but my instincts are telling me I should use my sony 600 TVL WDR board cam. I also just received a RMRC mini, and preliminary tests make it look attractive. So here are my main questions: 1) should I use just möbius for fpv? Or just board cam (15.3g) or mini (4.0g) ? Ideally I would have a video switcher and have the möbius and board can facing forward and the mini facing straight down,but dont have that yet. 2) If I use the board cam, it needs 12v and I am using immersionRC 600mw 5.8 which outputs 5v. I have a step up and a LC filter which weigh a combined 16.4g, mostly in the LC filter. The mini takes any voltage, so I could power it off the tx voltage out. I am powering my FC with a Turnigy low RF noise 5A UBEC. With all of that in mind, should I use the LC filter with either setup? If not do you think I will have problems with interference powering everything off the flight battery? Thanks in advance to everyone for any suggestions or tips, it is much appreciated. FYI I am looking to do racing style flying ultimately, but for now probably just some park flying.
Posted on: Sat, 27 Sep 2014 07:34:29 +0000
Trending Topics
Recently Viewed Topics
© 2015