Ok guys, to engrave or not to engrave. I have used paint over the - TopicsExpress



          

Ok guys, to engrave or not to engrave. I have used paint over the years but it always wears off. I have taken to using a 2 x aaa battery powered engraver to engrave my hard ware. I try to engrave my biners on the gate ( either the base of the gate or on the locking sheeve ) but devices i end up looking for the fattest section of the device. Its only a battery powered engraver thats scratching the anodising with 3-4 letters...so if its a descender or pulley, etc, i always stay from the connection point. I dont carve a groove just scratch a permanent mark. Thoughts?
Posted on: Mon, 07 Jul 2014 04:44:35 +0000

Trending Topics



Recently Viewed Topics




© 2015