You are troubleshooting a NAT connectivity problem on a Cisco router. You determine that the appropriate translation is not installed in the translation table. Which three actions should you take? (Choose three.) A. Determine if there are enough addresses in the NAT pool. B. Run debug ip nat detailed to determine the source of the problem. C. Use the show ip route command to verify that the selected route exists. D. Verify that the router interfaces are appropriately defined as NAT inside or NAT outside. E. Verify that the ACL referenced by the NAT command is permitting all necessary inside local IPv4 addresses. Not sure? Check this out! freeccnastudyguide/study-guides/ccna/ch10/565-2/
Posted on: Wed, 21 May 2014 14:20:40 +0000
Trending Topics
Recently Viewed Topics
© 2015