Be safe this ice fishing season always make sure the ice is thick enough. Here are some tips to check the thickness of the ice. Checking ice thickness Before heading out on ice: Contact a local bait shop or lakeside resort to ask about ice conditions. Check ice thickness once you get there. Temperature, snow cover, currents, springs and rough fish all affect the relative safety of ice. Ice is seldom the same thickness over a single body of water; it can be two feet thick in one place and one inch thick a few yards away. Check the ice at least every 150 feet. Check ice thickness using the following: Ice chisel » Ice auger » Cordless drill » Tape measure » An ice chisel is a metal rod with a sharp, flat blade welded onto one end. Drive the chisel into the ice, using a stabbing motion, to create a hole. Next, measure ice thickness with a tape measure. There are 3 different kinds of augers: hand, electric and gas. Hand augers are low cost, light weight and quiet. Electric augers are also quiet, but use less manual labor than a hand auger. Gas augers drill through ice the fastest, but are heavier, noisier and generally more costly than hand or electric models. After drilling a hole with the ice auger, measure ice thickness with a tape measure. Cordless drill Using a cordless drill and a long, five-eighths inch wood auger bit, you can drill through eight inches of ice in less than 30 seconds. Most cordless drills that are at least 7.2 volts will work, but the type of bit is critical. You need a wood auger bit since they have a spiral called a flute around the shaft that metal drilling bits don’t. The flutes pull the ice chips out of the hole and help keep it from getting stuck, much in the way a full-sized ice auger works. After drilling a hole, measure ice thickness with a measure tape. Dry the bit and give it a quick spray of silicone lubricant after each use to prevent rust. Tape measure Use a tape measure to find ice’s true thickness. Put the tape measure into the hole and hook the bottom edge of ice before taking measurement. You can also use an ice fishermans ice skimmer with inch markings on the handle in place of the tape measure. Dont judge ice thickness by how easily a chisel or drill breaks the surface. It happens so quickly that it’s easy to overestimate the thickness. trucks in lake Additional recommendations Cars, pickups or SUVs should be parked at least 50 feet apart and moved every two hours to prevent sinking. Tip: Make a hole next to the car. If water starts to overflow the top of the hole - the ice is sinking and it’s time to move the vehicle.
Posted on: Tue, 16 Dec 2014 18:05:12 +0000
Trending Topics
Recently Viewed Topics
© 2015