SikaSet® Accelerator Set Accelerating Admixture Description A concentrated solution of accelerating, plasticizing, and shrinkage-reducing agents. It is added to Portland cement to produce quick setting mortar. Use To produce quick setting, low shrinkage, high strength concrete patches. It can be used for sealing leakages and for plugging water infiltrations in concrete. Advantages Rapid set time Low shrinkage Good adhesion High early strength & compressive strength. Dosage Added to the mixing water within the range 1:0 – 1:5 Instructions for Use Surface Preparation Chip away deteriorated, unsound substrate Clean cavity completely. Mixing SikaSet is to be used with fresh Portland cement. Actual initial and final setting time will vary with different brands of cement and job conditions, test with small quantities of cement to be used should be conducted on job site to determine proper dilution ratio for the desired setting time. Application As Waterplug Plug cement paste into crack or hole. Hold in place with hand, until it has hardened. As Dry Pack Mortar Used for patching concrete structures. Dry pack mortar is made with 1 part OPC + 2 sand + SikaSet diluted with 2 to 5 parts water, depending on setting time desired. Technical Data Form Clear liquid Specific Gravity Approx. 1.28 kg/ltr Storage Dry, cool, shaded place Shelf Life 1 years when unopened Packaging 200 kg drum/20 kg can Handling Precautions: Avoid contact with skin and eyes Wear protective gloves and eye protection during work If skin contact occurs, wash skin thoroughly. If in eyes, hold eyes open, flood with warm water and seek medical attention without delay. Table of Contents Back Sikaset2 ® Accelerator 2/2 Legal Notes The information, and, in particular, the recommendations relating to the application and end-use of Sika products, are given in good faith based on Sika’s current knowledge and experience of the product when properly stored, handled and applied under normal conditions in accordances with Sika’s recommendations. In practice, the differences in materials, substrates and actual site conditions are such that no warranty in respect of merchantability or of fitness for a particular purpose, nor any liability arising out of any legal relationship whatsoever, can be inferred either from this information, or from any written recommendations, or from any other advice offered. The user of the product must test the product’s suitability for the intended application and purpose. Sika reserves the right to change the properties of its products. The proprietary rights of third parties must be observed. All orders are accepted subject to our current terms of sale and delivery. Users must always refer to the most recent issue of the local Product Data Sheet for the product concerned, copies of which will be supplied on request
Posted on: Wed, 27 Aug 2014 07:25:19 +0000