Update from Maketoys Official solution to combiner waist issue, as well as that for Celeritas maketoys.jp/announcements/quantron-fixes-and-replacement-parts/ If you are having any difficulties with these parts please send us an email at [email protected] 2014.Oct.22 Quantron fixes and replacement parts We have found that there are 2 minor issues on the Quantron set, we have arranged for replacement parts to account as a repair these issues. 1) Off-centered waist joint. We have prepared an adjusted gear part for replacement to correct the possible off-centered look of this set. Please contact the retailer you purchased your figure set from to have them send you these parts. Please note! This part is 100% free of charge. a) To replace the gear, you will have to unscrew the 4 screws at the back of the waist, and carefully remove the back cover section. Take caution! There is a SPRING that can pop out when you remove the cover. b) Remove and replace the gear inside. Install the back cover again and replace the screws . CAUTION!! Make sure the spring is installed the same way it came out! 2) Slightly over-tightened head joint/combining port For the US version of this figure, the chest inner piece of Celeritas is just a little over tightened. This does not hurt the transformation of the figure but makes this piece a little stiff when trying to transform Celeritas. PLEASE NOTE! If your set didn’t comes with the replacement part, it has already fixed. a) Pop out the chest inner section from the body. There are no screws or anything holding this piece in and should pop our with just a little force. b) unscrew the head, screw it back together on the new part and then pop the new part back into the figure.
Posted on: Thu, 23 Oct 2014 02:59:02 +0000
Trending Topics
Recently Viewed Topics
© 2015