Multitasking on #RaspberryPi using Single C Code engineersgarage/embedded/raspberry-pi/multitasking-on-raspberry-pi-using-single-c-code In this project the Raspberrypi board is loaded with #Ubuntu and is remotely accessed using VNC. The Raspberrypi board is also connected to the internet. There are 26 connectors which can be taken out from the connector port of the Raspberrypi board. All the connector pins are taken out using 13*2 pin female connectors and at the other end of their wire 26 pin Burg stick male connectors are attached. The Burg stick male connectors allow each pin out from the Raspberrypi board to be plugged into the holes of a breadboard. To access the pins that coming out of the #Broadcom controller of the Raspberrypi board using C language, a C library is available called “bcm2835”
Posted on: Thu, 22 Jan 2015 06:30:00 +0000
Trending Topics
Recently Viewed Topics
© 2015